Hay Bale Chopping System CGS-2 + Hammer Mill model: H-119/7SN + Hammer Mill model: H-119/7SN
Number of blades in straw chopper: 574 pieces
Number of blades in hammer mill: 8/14 pieces
Number of hammers in hammer mill: 60 pieces
Size of chopped raw material at output: 3 mm - 10 mm, depending on the sieve
Main motor power of the chopper: 37/45 kW
Conveyor motor, chopper feeding belt: 3 kW
Feeding motor of the hammer mill: 1.5 kW
Main motor power of the hammer mill: 2 X 45 kW
Three-phase current: 400V, coil voltage 24V/230V within +/- 5% limits, frequency 50 Hz
Total installed power: 80/125 kW
Types of raw material: wheat straw, alfalfa, rapeseed, soybean, corn stalks, etc.
Technology used since 2022
Length: 7500mm + 2500mm extension of feeding belt
Hay bale chopping system CGS-2 consists of:
- Hay bale chopper CGS-2
- Hammer Mill model: H-119/7SN - 2 pieces
- Control and electrical panel, inverter, 10-meter three-phase cable
Optional accessories for hay bale chopping system CGS-2:
Soft Starter, Frequency Converter, Automation
Max overload sensors for bunker with automated stop and start
The Hay Bale Chopping System model CGS-2 is mainly designed for use in briquette and pellet production lines from straw or other plant residues.
Operating principle: CGS-2 model chopper - Stage I: crushing of cylindrical and rectangular straw bales; Stage II: fine grinding (hammer mill) model: H-119/7SN grinds the raw material to 3-10 mm. The final fraction is fully prepared for further briquette and pellet production or as feed and bedding for animals.
Hay bale chopper CGS-2 with straw hammer mill.